Ex p Solutions for Gas Analysers and Detectors
Gas analysis and detection systems are in widespread use across chemical and petrochemical processing industries. Many of the operating environments are classified as hazardous, so Ex protection and certification for the equipment is required.
Due to operational requirements & constraints, many of the possible Ex protection concepts are not suitable. Ex p (Purge & Pressurisation) provides the most flexible and cost-effective solution.
The client needed to install several Honeywell SPM Flex detectors around their zone 2 classified facility to detect any leakage of toxic gases. The detectors were not certified, so required an Ex protection solution, with a purged and pressurised enclosure as the best option. However, there was an additional complication in that the sample being drawn into the detector might also contain flammable gases, which potentially meant that the system would be classified as having an internal source of release (ISOR) under BS/EN 60079-2.
To mitigate that risk, a secondary detector was located at the primary toxic gas sample point to simultaneously monitor for flammable gas. If flammable gas was detected, then the overall system was shut down. This method permitted the complete system to be certified by Expo under its populated enclosure certificate, thereby avoiding significant costs and time from Notified Body involvement.
- Certification: suitable for ATEX/IECEx: Zone 1& 2; NEC Class 1 Div 1& 2 depending on configuration.
- T4 (135°C) typical
- Tamb -20°C to +55°C
- Model of detector/analyser to be protected
- Type of environment – hazardous zone, ambient temperature
- Certification required – ATEX, IECEx, NEC etc
- Gas to be detected
- Material of construction & ingress protection
- Push button controls required
- Power & data input connections